43
For connection of a remote printer to a terminal(s) in the IRC system, be sure to consult your authorized
SHARP dealer.
(1) Basic programming for the remote printer – master and satellite
With the following procedure, you can do basic programming for the remote printer(s) included in the
IRC system.
For initial setup of the remote printer, please consult your authorized SHARP dealer.
1. Enter the PGM2 mode from the mode selection window.
2. Select “2 SETTING” from the displayed menu.
The SETTING window will appear.
3. Select “14 DEVICE CONFIG” from the displayed menu.
The DEVICE CONFIG window will appear.
4. Select a remote printer (KP#1-KP#9) to be programmed from the displayed menu.
A corresponding setting window for the remote printer will appear.
5. Carry out the programming for the remote printer.
(See the next page for programming for individual remote printer items.)
• Be sure to consult your authorized SHARP dealer for the correct settings.
6. After completion of settings for desired programming items, touch the [EXIT] key.
The DATA NOT SAVED SAVE IT? dialogue will appear.
7. Select “1.SAVE.”
8. Programming for the remote printer
To Next Page
Loading...
