Sharp VC-A565U

11
Dimensions: 257 ⳯ 182 mm
VC-A565U/H965U (11-22)
Setting Up
Connecting the VCR
! Press POWER to turn the power off.
@ Press TV/VCR, current VCR Output Channel will appear on the LCD display.
# Each time TV/VCR is pressed for 2 seconds, the LCD display changes as follow:
• VCR Output Channel is automatically set during EZ Set Up.
1. If Channel 3 (or 4) is an active broadcast channel in your area, the Channel 4 (or 3) will be set.
2. If both channel are the active channel or none active channel, the VCR Output Channel will be set to Channel 3.
• Cancelled the EZ Set Up by pressing POWER during EZ Set Up before setting the Output Channel.
• VCR Output Channel will not change to previous VCR Output Channel if TV/VCR is pressed continuosly for more than 2
seconds.
RF 3 = Output Channel 3
RF 4 = Output Channel 4
Current Mode (CLOCK)
Press
TV/VCR
2 sec.
later
Release TV/VCR
Setting the 3 ↔ 4 Output Channel
The 3 ↔ 4 Output Channel lets you change the VCR OUTPUT to standard TV broadcasting signals. Both your
TV and VCR must be set to the same channel (i.e TV on channel 3 and VCR OUTPUT channel on 3 too).