Sharp VC-A565U

36
VC-A565U/VC-H965U (26-36)
Dimensions: 257 ⳯ 182 mm
Tamper Proof
With this feature, you can lock all VCR modes to prevent accidental change.
This function works even when the VCR power is off, thus preventing children from operating
the VCR or viewing select programmes while you are away from home.
Tamper Proof
! Press TAMPER PROOF on the remote control for about 2 seconds.
“
ÿ
” flashes and “ ” lights on the multi-function display.
@ Press TAMPER PROOF again.
“
ÿ
” remains lit on the multi-function display confirming that Tamper Proof has been activated.
# Now regardless of what other operating buttons are touched, the VCR will continue to operate in the present
mode.
(If Tamper Proof is activated during playback, once the tape reaches its end, the VCR automatically
rewinds the tape, turns its power off and ejects the tape.)
Disengaging Tamper Proof
• Press TAMPER PROOF for about 2 seconds.
“
ÿ
” starts flashing and then disappears. Now, Tamper Proof is disengaged.
Advanced Tamper Proof
! Press TAMPER PROOF on the remote control for about 2 seconds.
“
ÿ
” flashes and “ ” lights on the multi-function display.
@ Input the personal code number (4 digit code) with the numbered buttons. The personal code number you
have input is displayed on the multi-function display.
# Press TAMPER PROOF again.
“
ÿ
” remains lit on the multi-function display confirming that Tamper Proof has been activated.
$ Now regardless of what other operating buttons are touched, the VCR will continue to operate in the present
mode.
(If Tamper Proof is activated during playback, once the tape reaches its end, the VCR automatically
rewinds the tape, turns its power off and ejects the tape.)
Disengaging Advanced Tamper Proof
! Press TAMPER PROOF for about 2 seconds.
“
ÿ
” flashes and “ ” lights on the multi-function display.
@ Input the personal code number (4 digit code) you used to activate Advanced Tamper Proof with the
numbered buttons. The personal code number you have input is displayed on the multi-function display.
# Press TAMPER PROOF again.
“
ÿ
” disappears. Now, Tamper Proof is disengaged. If the code number is wrong, “ ” is displayed on
the multi-function display. Retry to input the right code number. Press TAMPER PROOF again.
• If power is interrupted for more than 5 seconds (power failure, etc.), Tamper Proof may disengage.
• If, Tamper Proof is on, you attempt to change modes by pressing any button, the “
ÿ
” indicator will flash on the multi-
function display.