19
Dimensions: 257 ⳯ 182 mm
VC-A565U/H965U (11-22)
Setting the Clock
$ Select a channel that carries EDS signals with ß/©.
Ex.: 07
• The number of channels that can be selected depends
on the mode setting on the CHANNEL PRESET screen.
See NOTE.
When using a cable box:
Input the output channel (02, 03 or 04) of the cable box.
% Press SET to enter. The screen returns to normal.
Press POWER to turn off the VCR.
The Auto Clock Setting function will automatically set the
clock.
Normal
Screen
佡佡
• If the EDS CH SET mode is set to MANUAL mode in Step # and a channel that does not carry EDS signal is selected in
Step $, the Auto Clock Setting function will not operate.
• In Step $, the number of channels that can be selected depends on the mode setting on the CHANNEL PRESET screen.
See the table below.
• In Step !, if you press MENU when operating the screen setting for the first time or after a power failure of more than 5
seconds, the LANGUAGE screen will appear.
• If you entered incorrect data during the setting procedure, re-enter the correct data in the following manner:
1 Use ß / © to select the data to be corrected.
2 Set the correct data with ∂ / ƒ.
3 After correcting the data in Step 2, press SET to enter.
• If you press MENU in Step %, the data will not be stored.
• If a button is not pressed within 3 minutes during the setting procedure, the screen will return to the normal screen.
Manual Clock Setting
• Turn on your TV and select the video channel. (See Setting the 3 ↔ 4 Output Channel.)
• Press POWER and then TV/VCR to select “VCR”. (“VCR” will light on the multi-function display.)
EDS CH SET AUTO MANUAL
EDS CH 07
ß
©
! Press MENU.
Select “CLOCK” with ∂/ƒ and then press SET.
@ Select “MANUAL” with ∂/ƒ and then press SET.
∂
ƒ
佡
SET UP
MENU
ENTER :SET EXIT :MENU
CHANNEL PRESET
SELECT :
CLOCK
LANGUAGE
TIMER
佡
佡
SELECT :
MANUAL
CLOCK
ENTER :SET EXIT :MENU
AUTO
∂
ƒ
AIR/CATV Channels to be selected
AIR
CATV
02 03 04 68 69 02
01 02 03 124 125 01
To Next Page
Loading...
