11
VC-A582U
VC-A582U(A)
VC-H982U
4. MECHANISM ADJUSTMENT, REPLACEMENT, ASSEMBLING AND CLEAN-
ING METHODS
The explanation given below relates to the on-site general service (field service) but it does not relates to the adjustment
and replacement which need high-grade equipment, jigs and skill. For example, the drum assembling, replacement and
adjustment service must be performed by the person who have finished the technical courses.
4-1 MECHANISM CONFIRMATION ADJUSTMENT JIG
So as to perform completely the mechanism adjustment prepare the following special jigs. So as to maintain the initial
performance of the machine the maintenance and check are necessary. Utmost care must be taken so that the tape is
not damaged. If adjustment needs any jig, be sure to sue the required jig.
JiGTG1200 CN
JiGMP0001 BY
1. Torque Cassette Meter JiGVHT-063 CZ
No. Jig ltem Part No. Code Configuration Remarks
JiGTG0090 CM
3. Torque Gauge Head JiGTH0006 AW
5.
JiGRH0002 BR
JiGSG2000 BS
JiGSG0300 BF
6.
7. JiGADP003 BK
8.
9.
JiGDRiVER11055
AR
2.
Torque Gauge
Tension Gauge
These Jigs are used for checking
and adjusting the reel disk height.
When fixing any part to the threaded
hole using resin with screw, use the
jig. (Specified torque 5 kg)
This cassette torque meter is used for check-
ing and adjusting the torque of take-up for
measuring tape back tension.
These Jigs are used for checking
and adjusting the torque of take-up
and supply reel disks.
Master Plane Jig and
Reel Disk Height
Adjusting Jig
Pinch pressing force
measuring jig
Reverse guide height
adjusting box driver
This Jig is used for height adjustment of the
reverse guide (for reverse guide height ad-
justment).
13. JiGRVGH-F18 BU
This screwdriver is used for adjusting the
guide roller height.
For X value adjustment
VROATSV CD
These tapes are especially used for
electrical fine adjustment.
VROEFZCS BG
1k — 19µm
This Jig is used for height
adjustment of the reverse guide.
Hex Wrench (1.5 mm) JiGHW0015 AE
Guide roller height
adjustment drive
12. JiGDRiVER-6 BM
10.
Alignment Tape
X value adjustment
gear type screw driver
Reverse Guide Height
Adjusting Jig
These Jigs are used for loosening or
tightening special hexagon type
screws.
This Jig is used with the tension
gauge. Rotary transformer clearance
adjusting jig.
There are two gauges used for the
tension measurements, 300 g and
2.0kg.
Hex Wrench (1.2 mm) JiGHW0012 AE
4. Torque Driver JiGTD1200 CB
Black Level
(only SYNC) signal
11. JiGDRiVERH-4 AP
Video Audio HiFi Audio Track
525 Monoscope 7k — 58µm
NTSC Color Bar 1k — 58µm
To Next Page
Loading...
