11
If problems persist contact the SHARP Helpline on tel: 0990-274277
BASIC OPERATION
IMMEDIATE RECORDING
SELECTION OF A CHANNEL
Select the channel by using the number buttons on the remote control, or select the
next/previous channel by pressing
CHANNEL [or].
To change between single digit and 2-digit channel numbers, press
AM/PM .
For example, for channel 24, press
AM/PM then press 2 4.
You can record the channel you are watching or a different channel.
1. Insert a video tape into your VCR.
2. Select the channel you wish to record on the VCR.
3. To start recording, press REC ().
4. To pause during recording, press PAUSE/STILL ().
5. To continue recording, press REC ().
6. To stop recording, press STOP ( ) once.
SIMPLE TIMED RECORDING:
1. To specify a stop time, press REC ().
2. Each additional press of REC ( ) will delay
the stop time by 10 minutes.
3. To stop recording at any time, press
STOP ( ) once.
NOTES:
• If the tape ends before the recording is complete the VCR will stop recording, rewind,
eject the tape and place the VCR into POWERSAVE/STANDBY mode, or just eject the
tape and place the VCR in POWERSAVE/STANDBY timer mode if the VCR is in timer
record mode.
• If the VCR ejects the video tape when you press
REC ( ) the tape is record
protected. i.e. record protection tab has been removed.
STOP 15:30
DPSS
INPUT SELECT
CHANNEL
AM/PM
SLOW
TAPE
SPEED
TV/VCR
REC
PAUSE/STILL
REW FF
PLAY / X2
STOP
78
0
9
Remote Control
TINS-3809UMZZ ENGLISH.book Page 11 Monday, April 3, 2000 2:03 PM
To Next Page
Loading...
