Sharp VC-M333HM(S)

24
If problems persist contact the SHARP Helpline on tel: 0990-274277
SPECIAL FEATURES ON YOUR VCR
POST CODE SECURITY
This feature should allow the Police to identify you as the owner of the VCR if it is stolen. Each
time the VCR is turned on your postcode will be displayed for 5 seconds. Your postcode
cannot be changed or removed without first entering the correct PIN - number.
If you wish to use this function, follow the procedure below.
1.
Press
MENU
.
2. Press the [ / ] menu select buttons to
select SET UP. Press
SET
to confirm.
3.
Press [ / ] to select POST CODE. Press
SET
to confirm.
4.
Enter your desired PIN number using the
NUMBER BUTTONS or the [ / ]
buttons. This must be a 4 digit number in the
range
0000 - 9999.
5.
Using the [ / /
/]
buttons, enter your
Postcode. Press
SET
to confirm.
6.
Record your PIN number in the box provided
for future reference.
NOTE:
If you wish to change your PIN number at any time:
1.
Follow steps 1 to 3 above.
2.
Enter your current PIN number. Press
SET
to confirm
3.
Press to re-select PIN number.
4.
Enter your new PIN number. Press
SET
to confirm.
IMPORTANT:- Please keep your Operation Manual separate from your
VCR.
• Your Postcode can be changed at any time, but you must first enter your correct PIN
number. If the wrong PIN number is entered, an ERROR message will appear. Re-enter
the correct number.
POST CODE
P I N NUMBER POST CODE
---- ---- ---
SELECT :  CHANGE 
ENTER : SET EX I T :MENU
MENU SET
CLEAR
DISPLAY
C
PLUSCODE
MODE OSD
TIMER
ON/OFF
AUDIO
OUT
SKIP
SEARCH
ZERO
BACK
231
4
7
5
8
6
9
Remote Control
TINS-3809UMZZ ENGLISH.book Page 24 Monday, April 3, 2000 2:03 PM