27
If problems persist contact the SHARP Helpline on tel: 0990-274277
CUSTOMISED INSTALLATION
MANUALLY TUNING A CHANNEL
It should not be necessary to tune in a broadcast channel manually except in unusual
circumstances such as poor signal.
To manually tune in a channel follow the procedure below.
1. Press MENU.
2. Press the [ / ] menu select buttons
to select SET UP. Press
SET to confirm.
3. CHANNEL PRESET will be
highlighted. Press
SET.
4. Press [ / ] to select CHANNEL.
5. Press [/] to start tuning in either
direction. Tuning will stop when a channel
is received. If it is not the desired channel,
press
[/] to continue tuning.
6. Press [ / ] to select FINE
TUNING. Press and hold [/]until
the sharpest colour picture is obtained.
8. Press [ / ] to select SKIP.
The SKIP function determines whether the
channel can be selected when using the
CHANNEL / instead of the
NUMBER BUTTONS.
9. Press [/] to select ON or OFF for
this option.
10. Press SET to confirm.
11. Press MENU to leave this function.
IMPORTANT NOTE:
7. If you connect an independent
decoder, you must press [ / ] to
select DECODER, then select
[/] to
turn the decoder function ON.
CHANNEL PRESET
CHANNEL SORT
CLOCK
➔
PRESET 1
CHANNEL CH2 1
FINE TUNING
▲
▲
DECODER ON OFF
SKIP ON OFF
MENU SET
CLEAR
DISPLAY
PLUSCODE
MODE OSD
ON/OFF
OUT
SEARCH
BACK
231
Remote Control
TINS-3809UMZZ ENGLISH.book Page 27 Monday, April 3, 2000 2:03 PM
To Next Page
Loading...
