Sharp VC-MH75HM

16
www.sharp.co.uk/support
BASIC OPERATION
HOW TO CHECK, CHANGE AND CANCEL A DELAYED
RECORDING
Before you start!
• If the Timer Standby symbol
GG
GG
appears on the VCR display, press the
TIMER ON/OFF button to remove the
GG
GG
symbol.
CHECKING A RECORDING
1. Press the STOP button to switch on the VCR.
2. Press the MENU button.
3. Press the [ / ] menu select buttons to select
TIMER. Press the SET button to confirm.
• All the delayed recordings in the VCR’s memory
will be shown.
4. If the settings are correct press the MENU
button to exit.
• If you wish to change or cancel any settings, follow the procedures below.
CHANGING A RECORDING
1. Follow steps 1 to 3 of CHECKING A RECORDING
above.
2. To change a delayed recording, press the
[ / ] menu select buttons to highlight the
recording, then press the SET button to
select.
3. Press the [/] menu select buttons to highlight the setting to be changed and correct
it by using the [ / ] menu select buttons or the NUMBER buttons.
4. When all corrections are complete press the SET button to confirm, then press the
MENU button to exit.
CANCELLING A RECORDING
1. Follow steps 1 to 3 of CHECKING A RECORDING
above.
2. To cancel a delayed recording, press the
[ / ] menu select buttons to highlight the
recording to be cancelled, then press the
CLEAR button.
3. Press the MENU button to exit.
NOTE:
• If there are some programmes to be recorded, do not forget to press the TIMER ON/
OFF button to return the VCR to Timer Standby mode.
TIMER
ON/OFF
MENU SCREEN
TIMER
MOD E
SET UP
 : SELECT
SET : ENTER MENU : EX I T
STOP
MENU
SET
MENU
1/2
DATE PR START STOP
21/060212:0013:00SP
--/-- -- -:-- -:-- --
--/-- -- -:-- -:-- --
--/-- -- -:-- -:-- --
SET
SET
MENU
1/2
DATE PR START STOP
21/060212:0013:00SP
--/-- -- -:-- -:-- --
--/-- -- -:-- -:-- --
--/-- -- -:-- -:-- --
CLEAR
MENU
TIMER
ON/OFF
TINS-A724UMZZ.book Page 16 Monday, January 6, 2003 11:22 AM