29
www.sharp.co.uk/support
CUSTOMISED INSTALLATION
MANUALLY SETTING THE CLOCK
This procedure will allow you to set the clock manually.
1. Press the MENU button.
2. Press the [ / ] menu select buttons to
select SET UP.
Press the
SET button to confirm.
3. Press the [ / ] menu select buttons to
select CLOCK.
Press the
SET button to confirm.
4. Press the [ / ] menu select buttons to
select either 12 or 24 hour clock.
5. Press the [/] menu select buttons to select
TIME. Enter the time using the
NUMBER
buttons or the [ / ] menu select buttons. If
the minutes or hours are less than 10, enter the
leading 0. If using the 12 hour clock enter AM or
PM by pressing the
AM/PM button on the
remote control.
6. Press the [/] menu select buttons to select
DATE. Enter the date using the
NUMBER
buttons or the [ / ] menu select buttons.
For example, for 1st April enter
01 04.
7. Press the [/] menu select buttons to select
YEAR. Enter the last two digits of the year using
the
NUMBER buttons or [ / ]. For
example, for 2003 enter
03. For the year 2004
enter
04.
8. Press the SET button to confirm.
NOTE:
• You will need to update the clock for Summer/Winter daylight saving.
SET UP
CHANNEL PRESET
CHANNEL SORT
CLOCK
: SELECT : CHANGE
SET : ENTER MENU : EX I T
CLOCK
MODE T I ME DATE YEAR
24H 0:00 01/04 03
MODE: 24H / 12H
: SELECT : CHANGE
SET : ENTER MENU : EX I T
Remote Control
MENU
SET
ZERO
BACK
TIMER
ON/OFF
AUDIO
OUT
SKIP
SEARCH
SV/V+/
TIMER
CLEAR
MODE OSD
MENU
SET
MENU SELECT BUTTONS
3.
4.
MENU
SET
SET
AM/ PM
/
SET
TINS-A724UMZZ.book Page 29 Monday, January 6, 2003 11:22 AM
To Next Page
Loading...
