19
www.sharp.co.uk/support
ADVANCED OPERATION
PLAYBACK OF A VIDEO TAPE
CHECKING THE AMOUNT OF TAPE REMAINING
When you load a video tape into the VCR it can calculate approximately the amount of
video tape remaining in hours and minutes. This is useful in determining whether or not there is
sufficient tape left to make a recording. When a video tape is playing, the amount of tape
remaining is calculated for you automatically. To display the amount of video tape remaining:
1. Load the video tape into the VCR
2. Press the DISPLAY button on the remote control as many times as necessary until
“R” appears on the VCR display. The tape will wind forward and then return to its original
position. The tape remaining will be shown on the VCR display in hours and minutes. By
pressing the
TAPE SPEED button on the remote control the remaining time will
change between extended play, long play and standard play. For example:
In standard play mode, 1 hour 23 minutes is left on the tape:
In long play mode, 2 hours 46 minutes is left on the tape:
In extended play mode, 4 hours 9 minutes is left on the tape:
NOTES:
PLAYING BACK A VIDEO TAPE REPEATEDLY
You can set your VCR to automatically rewind at the end of playing a video tape and replay
the entire tape again. REPEAT will appear on the on-screen display when selected.
To use this feature:
1. Press the MENU button to display the main
menu on the screen.
2. Press the [ / ] menu select buttons to
select MODE.
3. Press the SET button.
4. Press the [ / ] menu select buttons to
select REPEAT.
5. Press the [ / ] menu select buttons to select ON.
6. Press the SET button to confirm and return to the main menu screen.
7. Press the MENU button to return to normal screen.
• If tape remaining function is interrupted, the remaining time will not be displayed.
• If less than 5 minutes of tape remains the display will flash.
DISPLAY
TAPE
SPEED
MODE MENU SCREEN
BLUE MUTE AUTO OFF
➝REPEAT ON OFF
: SELECT : CHANGE
S E T : EN T E R MENU : E X I T
MENU
SET
SET
MENU
TINS-A724UMZZ.book Page 19 Monday, January 6, 2003 11:22 AM
To Next Page
Loading...
