26
www.sharp.co.uk/support
CUSTOMISED INSTALLATION
MANUALLY TUNING A CHANNEL
• It should not be necessary to tune in a broadcast channel manually except in unusual
circumstances such as poor signal.
To manually tune in a channel follow the procedure below.
1.
Press the
MENU
button.
2.
Press the [ / ] menu select buttons to
select SET UP.
Press the
SET
button to confirm.
3.
CHANNEL PRESET will be highlighted.
Press the
SET
button.
4.
Press the [ / ] menu select buttons to
select CHANNEL.
5.
Press the
[/]
menu select buttons to
start tuning in either direction. Tuning will
stop when a channel is received. If it is not
the desired channel, press the
[/]
menu select buttons to continue tuning.
6.
Press the [ / ] menu select buttons to
select FINE TUNING. Press and hold the
[/]
menu select buttons
until the
sharpest colour picture is obtained.
IMPORTANT NOTE
7.
If you connect an independent decoder,
you must press the [ / ] menu select
buttons to select DECODER, then press the
[/]
menu select buttons to turn the
decoder function ON.
8.
Press the [ / ] menu select buttons to select SKIP. The SKIP function determines
whether the channel can be selected when using the
CHANNEL
/ buttons
instead of the
NUMBER
buttons. Press the
[/]
menu select buttons to select ON or
OFF for this option.
9.
Press the
SET
button to confirm.
10.
Press the
MENU
button to leave this function.
CHANNE L PRESE T
CHANNE L SORT
CLOCK
➔
PRESET 1
CHANNE L CH 2 1
FINE TUNING
▲
▲
DECODER ON OF F
SKIP ON OF F
MENU
SET
SV/V+/
TIMER
CLEAR
MODE OSD
DISPLAY
CHANNELAM/PM INPUT SELECT
/
K
L
REMOTE CONTROL
MENU
SET
SET
CHANNEL
K
To Next Page
Loading...
