Sharp VL-AX1U - Page 34

34
VL-AX1U
2.0Vp-p 0.1Vp-p
GND
Sig. center
5.6Vp-p 0.1Vp-p
3.2Vp-p 0.1Vp-p
GND
12. VF sub-brightness R/B adjustment
Test point TL8842(VR), TL8841(VG), TL8843(VB) Address VCR ADJ E9(R), VCR ADJ EA(B)
Mode VCR AV input
Procedure 1) Input white 40% signal into the AV input and standard monitor.
2) Adjust it with the VCR ADJ E9/EA so as to obtain the same color as the standard monitor.
Adjustment Standard monitor
rating
Examples • During IC705 or IC8800 replacement.
11. VFγ1 adjustment
Test point TL8841(VG) Address VCR ADJ EB
Mode VCR AV input
Procedure 1) Input the signal of a 3-step waveform.
2) Set VCR ADJ ED to 00.
3) Adjust the white 100% range of the waveform of TL8841 to 5.6±0.1Vp-p with VCR ADJ EB.
4) Then adjust the same waveform VCR ADJ E5 to 3.2±0.1Vp-p.
5) Return VCR ADJ ED to the initial value. (Initial value: 7A)
Adjustment 5.6 ± 0.1Vp-p (VCR ADJ EB)
rating 3.2 ± 0.1Vp-p (VCR ADJ E5)
Examples • During IC705 or IC8800 replacement.
10. VF contrast adjustment
Test point TL8841(VG) Address VCR ADJ E5
Mode VCR AV input
Procedure 1) Input the signal of a 3-step waveform.
2) Set VCR ADJ EB/ED to FF/00.
3) Adjust the pedestal 100% range of the waveform of TL8841 to the specified adjustment value.
4) Return VCR ADJ ED to the initial value. (Initial value: 7A)
Adjustment 2.0Vp-p ± 0.1Vp-p
rating
Examples • During IC705 or IC8800 replacement.