4-1
VL-E610S/VL-E610H
VL-E660S/VL-E96E
VL-E98E
4. MECHANISM ADJUSTMENT
4-1. Mechanism checking/adjusting jigs, tools and parts
4-1-1. Mechanism checking/adjusting jigs and tools
No. Name Part No. Code Configuration Model, Uses
Remarks
1 Cassette torque JiG8T-012 CV • (10 g.cm/25 g.cm)
meter for PB
2 Cassette torque - JiG8T-032 CV • (50 g.cm/25 g.cm)
meter for VS-REW
3 Torque gauge JiGTG0045 CN • For measurement
of loading
braketorque
4 Torque gauge head JiGTH-MX7U BS • For torque gauge
listed above
5 Torque driver JiGTD1500RTDH CB
(1.5 kg.cm)
6 Master plane JiGMP-MX7U CG • For adjustment
of Tu guide height
• For adjustment of
Si roller height
• For checking of
reel disk height
7 Height adjusting jig 9DAGH-E31S BM • For adjustment of
Tu guide height
• For adjustment of
Si roller height
8 Guide roller height JiGDRiVERHMX7U BU Bit shape
adjusting driver (See the figure below)
Tu guide height 9EQDRiVER-V712 BL
adjusting driver
9 Hex wrench • For loosening or
tightening of
Motor stator
(1.3mm)
Tolerance±0.1
2
Edge
thickness 0.5
1.8
4
2.5
ø2
3
ø4
To Next Page
Loading...
