Sharp VL-H870S

VL-H870U
VL-H875U
VL-H890U
VL-H860S/H/VL-H870S
VL-H890S/VL-H94E
VL-H96E/VL-H960E
VL-H860S/H/VL-H870S
VL-H890S/VL-H94E
VL-H96E/VL-H960E
3-2
<2. Remove the Tripod Angle.>
(d)
(d)
(1) Remove the screws (d)XiPSF20P04000(3pcs.), pull the Tri-
pod Angle.
Tripod Angle
<3. Removal of the LCD unit>
<4. Removal of the V.Cabinet>
(2) Turn the Camera section to right angle, remove the Tilt side
fixing screws (g)LX-HZ0045TAFF(2pcs.), the bottom side
screw (b)LX-HZ0018TAFF(1pc.), open the VCR lid, and
remove the slant wise screw (d)XiPSF20P04000(1pc.).
Note:
The Tilt section is setting with the parts of the Camera section .
(Never remove the parts of Camera section only.)
(1) • Firstly, remove the Lithium Holder.
• Turn to upside the surface of V.lid, remove the
V.Cabinet fixing screw (b)LX-HZ0018TAFF(1pc.).
Remove the Lithium
Holder
(f)
Microphone connector
(f)
Main PWB
(f)
(3) Remove the Microphone connector.
Remove the main PWB fixing screws (f)XiPSD20P03000(3pcs.).
Lift the main PWB in the arrow direction and remove the
connection "B to B".
<5. Removal of the main P.W.B>
Camera FPC
Lithium connector
(1) Remove the Camera FPCs(2pcs.) are connected with main
PWB and the Camera section, and remove the Lithium
connector.
Remove the battery
connector
(2) The same as process 4., remove the battery connector in the
reverse side of PWB and EJECT TURN S.W. connector, and
disconnect the Tilt section and main PWB.
<6. Removal of the Cabinet and Mechanism>
(b)
(e)
(e)
(d)
(1) Remove the screws (b)LX-HZ0018TAFF(1pc.), (d)
XiPSF20P04000(3pcs.) and (e)LX-BZ0191TAFD(2pcs.).
(2) Pull the Mechanism from K.S.V.Cabinet, remove the screw
(e)LX-BZ0191TAFD(1pc.) and the side angle.
(e)
Side angle
(b)
V.Cabinet
(d)
(b)
(g)
(1) Remove the FPCs from connectors A, B and C.
("C" isn't used with VL-H860S/H94E/EX.)
(2) Remove the screws (d)XiPSF20P04000(1pc.) and (b)LX-
HZ0018TAFF(1pc.).
(b)
(d)
Inverter transformer
B
A
C
LCD unit
Remove EJECT TURN
S.W. connector
Main PWB