Sharp WQ-T281Z - Specifications

~ WO-T281Z
sy
(—
GENERAL
Power source:
Speakers:
Output power:
Input impedance:
Loaded impedance:
Dimensions:
Weight:
FOR A COMPLETE DESCRIPTION OF THE OPERATION OF THIS UNIT,
PLEASE REFER TO THE OPERATION MANUAL. |
SPECIFICATIONS
AC 110—127 V and
220—240 V, 50/60 Hz DC 15 V
(UM/SUM-2 or R14 type x 10)
10cm woofer x 2
Horn type tweeter x 2
PMPO; 60 W (30 W + 30 W)
(AC operation)
MPO; 24W (12W+12W)
(AC operation)
RMS; 15 W (7.5W+7.5 W)
(DC operation,
10% distortion)
External mic; 600 ohms
Line in; 50 kohms
Headphones: 32 ohms or
greater
Width; 440 mm
Height; 135mm
Depth; 144 mm
4.0 kg without batteries
TAPE RECORDER
Tape:
Frequency response:
Signal/noise ratio:
Compact cassette tape
50 Hz — 14,000 Hz (normal tape)
55 dB (Deck 1, playback)
50 dB (Deck 2, normal tape
recording)
Wow and flutter: 0.17% (WRMS)
RADIO
Frequency range: FW: 87.6 — 108 MHz
SWi; 2.3 — 7.3 MHz
SW2; 7.3 — 22 MHz
AM: 526.5 — 1,606.5 kHz
_ Specifications for this model are subject to change without
_ prior notice.
STRINGING OF DIAL CORD
1. Turn the drum fully in the direction (A) shown in Fig. 2—2
and stretch its cord over the parts in the numerical order.
2. Then turn the tuning control shaft fully in the direction ‘B
shown in Fig. 2—2 and fix :ts pointer as shown in Fig. 2—1.
Dial Pointer (207)
|
“O'' Point
Figure 2—1
Dial Cord Assembly (203)
Tuning Knob (214)
Sy
SS
Sw
)
>
Pulley (228) 6 S\—
y | Pr SS
Yr | oe Pulley (228)
Pulley (228) SS
\ pulley (227)
Drum (225)
Figure 2—2