For further information, please read the instruction manual.
Tu
rn the mode switch to the Z/PGM position.
Before Starting Entries
Tu
rn the mode switch to the REG position.
NOTE
Your cash register is pre-programmed so that you can use it with minimum set-up.
To
change the settings, see the instruction manual.
Initial settings
Departments 1-4: Taxable 1 ; Departments 5-8: Non-taxable
R: Tax rate (0.0000% to 99.9999%) x 10000
(Enter the rate in 6 digits. Leading zeros may be omitted.)
Q: Minimum taxable amount (0.01 to 99.99) x 100
(Smallest amount for which tax must be collected. )
*Up to 4 types of tax are programmable.
Example 1: Tax rate 7.0000%, Min. taxable amount $0.11 for Tax 1
Example 2: Tax rate 4.0000%, Min. taxable amount $0.00 for Tax 2
Setting Tax Rates (%)
Specify a tax rate (%) for calculation of tax on each taxable subtotal using the
follow
ing sequence:
Setting the Date
Enter the date in 6 digits using the month-da
y-year fo
rmat. Press the
key once
to program
the next
item or twice to exit the programming mode.
Example:
Setting the Time
Enter the time in 4 digits (“hhmm” format) using the 24 hour system. Press the
.
(Once the clerk code entered, re-entry of
the clerk code is not needed until the clerk is changed.)
Clerk code
Registration Example
(When the Customer Pays by Cash)
Reading and Resetting
X Reports (reading)
Turn the mode switch to the X/Flash position and press
.
Z Reports (reading and resetting)
In the Z/PGM mode, press .(In this case, grand total resetting is not performed.)
Flash Reports (displayed but not printed)
In the X/Flash mode:
Press dept. key for dept. sales reports
Press
To Previous Page
Loading...
