XG-P25X
17
6. Removing the power / ballast / sound-out / bimetal unit assembly.
6-1. Remove the screw and disconnect the grounding wire from the shield case of the power/ballast unit.
6-2. Disconnect the connectors from the sound out PWB.
6-3. Take out the bimetal socket.
6-4. Remove the two screws and detach the lamp socket.
6-5. Remove the three screws and detach the power unit.
6-6. Remove the screw and slide the bimetal assembly upward out of position.
6-5
6-1
6-2
6-3
6-3
6-6
6-4
Bimetal Ass'y
Sound Out PWB
Power/Ballast Unit
To Next Page
Loading...
