11
COMPACT DISC OPERATION
■ CD playback
1 Press the ON/STAND-BY button to turn the
power on.
2 Press the FUNCTION button until “Cd” or “no
dISC” appears in the display.
● Press the CD button on the remote control.
● If no disc is loaded, the display will be “no dISC”
instead of “Cd”.
3 Press the 7 CD EJECT button to open the CD
compartment.
4 Place a compact disc on the spindle, label side
up.
5 Close the CD compartment by firmly pushing
the corner marked “PUSH CLOSE”.
● The total number of tracks and the total playing
time will be displayed.
6 Press the
0
/ CD
6
(
0 6
) button to start play-
back from track 1.
● When the last track on the disc has finished play-
ing, the unit will stop automatically.
To interrupt playback:
➀
Press the 0 / CD 6 (
0 6
) button.
➁
Press the 0 / CD 6 (
0 6
) button again to
resume playback from the same point.
To stop playback:
Press the ■ button.
After use:
Press the ON/STAND-BY button to enter the stand-
by mode.
Caution:
● Do not open the CD compartment during play-
back (or whilst paused).
● If the disc is damaged, dirty, or loaded upside
down, “no dISC” or “Cd Error” will appear in the
display.
Clean, replace, or reload the disc properly.
● Keep foreign objects out of the CD compartment.
● Subjecting the unit to shock or vibration may
cause mistracking.
● When the unit is not being used, be sure to close
the CD compartment. If it is left open, the lens
may become covered with dust and the unit may
not operate properly.
● Playing certain compact discs at a high volume
may cause mistracking. In this case, listen at
lower volume.
● If TV or radio interference occurs during CD op-
eration, move the unit away from the TV or ra-
dio.
1
2
6
4
2
1
6
/CD
5
PUSH
CLOSE
3
7CD EJECT
Label side up
*XL-30H(SUK)P09-P13 00.2.8, 2:34 PM11
Downloaded from: http://www.usersmanualguide.com/
To Next Page
Loading...
Need help?
General
