02/11/22 XL_35W_SCA_3.fm
21
XL-35W
Tape Recording
Recording to a cassette tape
Before recording:
!
When recording important selections, make a preliminary test to
ensure that the desired material is properly recorded.
!
SHARP is not liable for damage or loss of your recording arising
from malfunction of this unit.
!
The volume and sound controls can be adjusted with no effect on
the recorded signal (Variable Sound Monitor).
!
For recording, use only normal tapes. Do not use metal or
CrO tapes.
"
Recording from a CD
Erase-prevention tabs of cassette tapes:
!
When recording on a cassette tape, make
sure that the erase-prevention tabs are not
removed. Cassettes have removable tabs
that prevent accidental recording or erasing.
!
To protect the recorded sound, remove the
tab after recording. Cover the tab hole with
the adhesive tape to record on the tape with-
out the tab.
Side A
Tab for
side B
Tab for
side A
1
Press the ON/STAND-BY button to turn the power on.
2
Press the FUNCTION button until "CD STOP" appears on
the display.
When operating with the remote control, press the CD button.
3
Load the desired disc.
4
Load a cassette into the cassette compartment with the
side to be recorded on facing you.
Wind past the leader of the tape, on which recording cannot be
performed.
5
Press the button.
Recording will be paused.
6
Press the ( ) button.
!
CD playback will start in a few seconds after the tape starts.
!
When the playback of the disc is finished, the CD and the
cassette will stop automatically.
To Next Page
Loading...
