02/11/22 XL_35W_SCA_3.fm
26
XL-35W
References
Troubleshooting chart
Many potential problems can be resolved by the owner without call-
ing a service technician.
If something is wrong with this product, check the following before
calling your authorised SHARP dealer or service centre.
"
General
"
CD player
"
Tuner
"
Cassette deck
"
Remote control
Symptom Possible cause
The clock is not set
to the correct time.
!
Did a power failure occur? Reset the clock
(refer to page 12).
When a button is
pressed, the unit
does not respond.
!
Set this unit to the power stand-by mode
and then turn it back on.
!
If the unit still malfunctions, reset it. (Refer
to page 27.)
No sound is heard.
!
Is the volume level set to "MIN"?
!
Are the headphones connected?
!
Are the speaker wires disconnected?
Playback does not
start.
!
Is the disc loaded upside down?
Playback stops in
the middle or is not
performed proper-
ly.
!
Does the disc satisfy the standards?
!
Is the disc distorted or scratched?
Playback sounds
are skipped, or
stopped in the mid-
dle of a track.
!
Is the unit located near excessive vibra-
tions?
!
Is the disc very dirty?
!
Has condensation formed inside the unit?
The radio makes un-
usual noises contin-
uously.
!
Is the unit placed near the TV or comput-
er?
!
Is the FM or AM aerial placed properly?
Move the aerial away from the AC power
lead if it's located nearby.
Cannot record.
!
Is the erase-prevention tab removed?
Cannot record tracks
with proper sound
quality.
!
Is it a normal tape? (You cannot record on
a metal or CrO tape.)
Cannot erase com-
pletely.
Sound skipping.
!
Is there any slack in the tape?
Cannot hear treble.
!
Is the tape stretched?
Sound fluctuation.
!
Are the capstan, pinch roller, or heads
dirty?
Cannot remove the
tape.
!
If a power failure occurs during playback,
the heads remain engaged with the tape.
Do not open the compartment forcibly.
Wait until electricity resumes.
The remote control
does not operate.
!
Is the AC power lead of the unit plugged in?
!
Is the battery polarity correct?
!
Are the batteries dead?
!
Is the distance or angle incorrect?
!
Does the remote control sensor receive
strong light?
To Next Page
Loading...
