E-17
Enhancing your system
The connection cord is not included. Purchase a commer-
cially available cord as shown below.
Audio cable (not supplied)
Portable audio
player, etc.
■ Listening to the playback sounds of
portable audio player, etc.
1 Use a connection cord to connect the portable audio
player, etc. to the AUDIO IN jack.
2 Press the ON/STANDBY button to turn the power on.
3 Press the AUDIO/LINE (INPUT) button (remote con-
trol) or FUNCTION button repeatedly (main unit) to
select AUDIO IN function.
4 Play the connected equipment. If volume level of the
connected device is too high, sound distortion may
occur. Should this happen, adjust the volume of the
connected device.
Note:
To prevent noise interference, place the unit away from
the television.
■ Headphones
● Do not set the volume on to maximum at switch on.
Excessive sound pressure from earphones and head-
phones can cause hearing loss.
● Before plugging in or unplugging the headphone, re-
duce the volume.
● Be sure your headphone has a 1/8” (3.5 mm) diameter
plug and impedance between 16 and 50 ohms. The
recommended impedance is 32 ohms.
● Plugging in the headphone disconnects the speakers au-
tomatically.
Troubleshooting chart
If something is wrong with this product, check the following
before calling your authorized SHARP dealer or service
center.
■ General
Symptom Possible cause
● The clock is not set to
the correct time.
● A power failure occurred.
Reset the clock. (Refer
page 15)
● When a button is
pressed, the unit does
not respond.
● Set the unit to the power
standby mode and then
turn it back on.
● If the unit still
malfunctions, reset it.
(Refer page 19)
● No sound is heard. ● The volume level set to
“Min”.
● The headphones are not
connected.
● The speaker wires are not
connected.
● The unit is too far from the
Bluetooth stereo audio
source device.
● The unit is not paired with
the Bluetooth stereo audio
source device.
■ Remote control
Symptom Possible cause
● The remote control
does not operate.
● The AC power cord of the
unit is not plugged in.
● The battery polarity is
wrong.
● The battery is dead.
● The distance or angle is
incorrect.
● The remote control sensor
receives strong light.
■ Bluetooth
Symptom Possible cause
● No sound is heard. ● The unit is too far from the
Bluetooth stereo audio
source device.
● The unit is not paired with
the Bluetooth stereo audio
source device.
● Bluetooth sound
is interrupted or
distorted.
● The unit is too near to
a device that generates
electromagnetic radiation.
● There is an obstacle
between the unit and the
Bluetooth stereo audio
source device.
To Next Page
Loading...
Need help?
General
