Sharp XL-HF202PH - Timer and Sleep Operations; Timer Playback Setup

E-17
4 While the selected programme type is ashing
(within 6 seconds), press the RDS PTY button
again.
After the selected programme type has been lit for 2 sec-
onds, “SEARCH” will appear, and the search operation will
start.
Notes:
● If the display has stopped ashing, start again from
step 2. If the unit nds a desired programme type, the
corresponding channel number will lit for about 8 sec-
onds, and then the station name will remain lit.
● If you want to listen to the same programme type of
another station, press the RDS PTY button while the
channel number or station name is ashing. The unit
will look for the next station.
● If no station can be found, “NOT FOUND” will appear
for 4 seconds.
If you select the trafc programme:
If you select the trafc programme (TP) in step 3, “TP”
will appear.
(This does not mean that you can listen to the trafc infor-
mation at that time.)
When the trafc information is broadcast, “TA” will appear.
Descriptions of the PTY (Programme Type) codes, TP
(Trafc Programme) and TA (Trafc Announcement)
NEWS POP M SOCIAL FOLK M
AFFAIRS ROCK M RELIGION DOCUMENT
INFO EASY M PHONE IN TEST
SPORT LIGHT M TRAVEL ALARM
EDUCATE CLASSICS LEISURE NONE
DRAMA OTHER M JAZZ TP
CULTURE WEATHER COUNTRY TA
SCIENCE FINANCE NATION M
VARIED CHILDREN OLDIES
Using the Radio Data System (RDS) (continued)
Timer playback:
The unit turns on and plays the desired source (CD, TUN-
ER, USB, iPod, AUDIO IN, LINE IN) at a preset time.
This unit has 2 types of timer: ONCE TIMER and DAILY
TIMER.
Once timer (“
” indicator):
Once timer play works for one time only at a preset time.
Daily timer (“DAILY” indicator):
Daily timer play works at the same preset time every day
that we set. For example, set the timer as a wake-up call
every morning.
Using the once timer and daily timer in combination:
For example, use the once timer to listen to a radio pro-
gramme, and use the daily timer to wake up.
1 Set the daily and once timer (pages 17 - 18).
1 minute or more
Daily timer Once timer
Stop StartStart Stop
■ Timer playback
Before setting timer:
● Check that the clock is set to the correct time (refer
to page 6). If it is not set, you cannot use the timer
function.
● For timer playback: Plug in USB or load discs or dock
iPod to be played.
1 Press the ON/STAND-BY button to turn the power on.
2 Press and hold the CLOCK/TIMER button.
3 Within 10 seconds, press the or button to select
“Once” or “Daily”, and press the ENTER button.
4 Within 10 seconds, press the or button to select
“Timer Set”, and press the ENTER button.
5 To select the timer playback source (CD, TUNER,
USB, iPod, AUDIO IN, LINE IN), press the or
button. Press the ENTER button.
When you select the tuner, select a station by pressing
the
or button, and then press the ENTER but-
ton. If a station has not been programmed, “No Preset”
will be displayed and timer setting will be cancelled.
6 To adjust the day, press the or button and then
press the ENTER button.
7 Press the ENTER button to adjust the hour. Press the
or button and then press the ENTER button.
8 To adjust the minutes, press the or button and
then press the ENTER button.
9 Set the time to nish as in steps 7 and 8 above.
10 Adjust the volume using the VOLUME control, and then
press the ENTER button.
Timer and sleep operation (Remote control only)