Sharp XL-HP500H - Recording to a cassette tape; Recording from a CD (CDs); Recording from the radio

02/7/23 XL-HP500H(H)E2.fm
E-18
ENGLISH
8
XL-HP500H
Tape Recording
Recording to a cassette tape
Before recording:
"
When recording important selections, make a preliminary test to
ensure that the desired material is properly recorded.
"
SHARP is not liable for damage or loss of your recording arising
from malfunction of this unit.
"
The volume and sound controls can be adjusted with no effect on
the recorded signal (Variable Sound Monitor).
"
For recording, use only normal tapes. Do not use metal or CrO
tapes.
! Recording from a CD (CDs)
You can record the desired CD using the DISC SELECT - ( 1
- 3) buttons.
1
Press the ON/STAND-BY button to turn the power on.
2
Press the CD button and load the desired disc.
3
Load a cassette into the cassette compartment with side A
facing you.
Wind past the leader of the tape, on which recording cannot be
performed.
4
Press the button to choose one side or both sides.
... To record on both sides.
... To record on only one
side.
5
Press the button.
Recording will be paused.
6
Press one of the DISC SELECT - ( 1 - 3) buttons to
start recording.
"
To record on both sides, begin on side A. (If recording is
started from side B, the tape will not switch over to side A.)
"
Recording is started from the selected CD. When the play-
back of the last track is finished or the end of the tape is
reached, the CD and the cassette will stop automatically.
"
CD playback will start approximately 7 seconds after the
tape starts.