15
8
7
6
5
4
3
2
1
9
10
05/1/28 XL-MP60(U).fm
TINSEA043SJZZ
XL-MP60
Basic Operation
Setting the clock
In this example, the clock is set for the 12-hour (AM 12:00) display.
To confirm the time display:
Note:
The "CLOCK" or time will flash at the push of the CLOCK button
when the AC power supply is restored after a power failure or
unplugging the unit.
Readjust the clock as follows.
To readjust the clock:
Perform "Setting the clock" from step 1. If the "CLOCK" is not flash-
ing in step 1, step 2 (for selecting the 12-hour or 24-hour display) will
be skipped.
To change the 12-hour or 24-hour display:
1 Press the CLOCK button and within 8 seconds, press the
MEMORY/SET button.
2 Within 30 seconds, press the PRESET ( or ) button to
select 12-hour or 24-hour display and then press the MEM-
ORY/SET button.
"AM 12:00" The 12-hour display will appear.
(AM 12:00 - PM 11:59)
"0:00" The 24-hour display will appear.
(0:00 - 23:59)
3 Within 30 seconds, press the PRESET ( or ) button to
adjust the hour and then press the MEMORY/SET button.
Press the PRESET ( or ) button once to advance the time
by 1 hour. Hold it down to advance continuously.
4 Within 30 seconds, press the PRESET ( or ) button to
adjust the minutes and then press the MEMORY/SET but-
ton.
Press the PRESET ( or ) button once to advance the time
by 1 minute. Hold it down to advance continuously.
Press the CLOCK button.
The time display will appear for
about 8 seconds.
1 Clear all the programmed contents. [Refer to "Clearing all the
memory (reset)" on page 30 for details.]
2 Perform "Setting the clock" from step 1.
To Next Page
Loading...
