Sharp XL-MP60 - Listening to the Radio

24
05/1/28 XL-MP60(U).fm
TINSEA043SJZZ
XL-MP60
Radio
Listening to the radio (continued)
! Memorizing a station
You can store 40 AM and FM stations in memory and recall them at
the push of a button. (Preset tuning)
Note:
The backup function protects the memorized stations for a few hours
should there be a power failure or the AC power cord get discon-
nected.
! To recall a memorized station
! To scan the preset stations
The stations saved in memory can be scanned automatically. (Pre-
set memory scan)
! To erase entire preset memory
1 Perform steps 1 - 3 in "Tuning" on page 23.
2 Press the MEMORY/SET button to enter the preset tuning
saving mode.
3 Within 30 seconds, press the PRESET ( or ) button to
select the preset channel number.
Store the stations in memory, in order, starting with preset
channel 1.
4 Within 30 seconds, press the MEMORY/SET button to store
that station in memory.
If the "MEMORY" and preset number indicators go out before
the station is memorized, repeat the operation from step 2.
5 Repeat steps 1 - 4 to set other stations, or to change a pre-
set station.
When a new station is stored in memory, the station previously
memorized will be erased.
Press the PRESET ( or ) button for less than 0.5 seconds to se-
lect the desired station.
1 Press the PRESET ( or ) button for more than 0.5 seconds.
The preset number will flash and the programmed stations will be
tuned in sequentially, for 5 seconds each.
2 Press the PRESET ( or ) button again when the desired sta-
tion is located.
1 Press the ON/STAND-BY button to enter the stand-by mode.
2 While pressing down the TUNER(BAND) button and the 2 but-
ton, press the ON/STAND-BY button until "TUNER CL" appears.