04/3/25 XLMP80HH_E.fm
E-9
ENGLISH
XL-MP80H
TINSZA021SJZZ
Basic Operation
Setting the clock
This may be operated only with the remote control.
In this example, the clock is set for the 24-hour (0:00) display.
To confirm the time display:
Press the CLOCK button.
The time display will appear for about 7 seconds.
Note:
The time will flash at the push of the CLOCK button when the AC power
supply is restored after a power failure or unplugging the unit.
Readjust the clock as follows.
To readjust the clock:
Perform "Setting the clock" from the beginning. If the "0:00" is not flash-
ing in step 1, step 2 (for selecting the 24-hour or 12-hour display) will be
skipped.
To change the 24-hour or 12-hour display:
1 Press the CLOCK button and within 7 seconds, press the
MEMORY button.
2 Press the PRESET ( or ) button to select 24-hour or 12-
hour display and then press the MEMORY button.
"0:00" The 24-hour display will appear.
(0:00 - 23:59)
"AM 12:00" The 12-hour display will appear.
(AM 12:00 - PM 11:59)
3 Press the PRESET ( or ) button to adjust the hour and
then press the MEMORY button.
"
Press the PRESET ( or ) button once to advance the time
by 1 hour. Hold it down to advance continuously.
"
When the 12-hour display is selected, "AM" will change au-
tomatically to "PM".
4 Press the PRESET ( or ) button to adjust the minutes
and then press the MEMORY button.
"
Press the PRESET ( or ) button once to advance the time
by 1 minute. Hold it down to advance continuously.
" The hour will not advance even if minutes advance from "59"
to "00".
1 Clear all the programmed contents. [Refer to "Clearing all the memory
(reset)" on page 31 for details.]
2 Perform "Setting the clock" from the beginning.
To Next Page
Loading...
