Sharp XL-S15H - Listening to the Memorised Station

04/3/31 XL-S15H_E_2.fm
17
TINSEA028SJZZ
XL-S15H
8
7
6
5
4
3
2
1
9
10
Radio
Listening to the memorised station
" Memorising a station
You can store 40 AM and FM stations in memory and recall them at
the push of a button. (Preset tuning)
Note:
The backup function protects the memorised stations for a few
hours should there be a power failure or the AC power lead discon-
nection.
" To recall a memorised station
" To scan the preset stations
The stations saved in memory can be scanned automatically. (Pre-
set memory scan)
" To clear a memorised station
1 Perform steps 1 - 3 in "Listening to the radio" on page 16.
2 Press the MEMORY/SET
(MEMORY) button to enter the
preset tuning saving mode.
3 Within 5 seconds, press the
PRESET ( or ) button to se-
lect the preset channel num-
ber.
Store the stations in memory, in order, starting with preset
channel 1.
4 Within 5 seconds, press the
MEMORY/SET (MEMORY)
button to store that station in
memory.
If the "MEMORY" and preset number indicators go out before
the station is memorised, repeat the operation from step 2.
5 Repeat steps 1 - 4 to set other stations, or to change a pre-
set station.
When a new station is stored in memory, the station previously
memorised will be erased.
Press the PRESET ( or ) button for less than 0.5 seconds to
select the desired station.
Preset channel Frequency and frequency band
1 Press the PRESET ( or ) button for more than 0.5 sec-
onds.
The preset number will flash and the programmed stations will
be tuned in sequentially, for 5 seconds each.
2 Press the PRESET ( or ) button again when the desired
station is located.
1 Recall the memorised station.
2 Whilst it is displayed, press the MEMO-
RY/SET (MEMORY) button.
3 Within 5 seconds, press the CLEAR but-
ton on the remote control.
Downloaded from: http://www.usersmanualguide.com/