Sharp XP-A201U-B - Power Supply; Installation

EN-5
WARNING
Power supply
Use a suitable voltage power supply.
REQUIRED
• This projector is designed to be used with a 100–240 VAC, 50/60 Hz power supply. Before using the projector, check that
the power supply to which the projector is to be connected meets these requirements.
• Use a power outlet as the projector’s power supply. Do not connect the projector directly to electrical light wiring. Doing
so is dangerous.
Connecting the power cord to earth
MUST BE
EARTHED
• This equipment is designed to be used in the condition of the power cord connected to earth. If the power cord is not con-
nected to the earth, it may cause electric shock. Please make sure the power cord is connected to the wall outlet directly
and earthed properly.
Do not use a 2-pin plug converter adapter.
• Be sure to connect the projector and the computer (signal source) to the same earth point. If the projector and the computer
(signal source) will be connected to dierent earth points, uctuations in the earth potential may cause re or smoke.
Handling the power cord
REQUIRED
• Please use the power cord supplied with this projector. If the supplied power cord does not satisfy requirements of your
country’s safety standard, and voltage and current for your region, make sure to use the power cord that conforms to and
satises them.
• The power cord you use must be approved by and comply with the safety standards of your country.
Please refer to the “Specications” in the user’s manual about the power cord specication.
For selecting an appropriate power cord, please check rated voltage for your region by yourself.
PROHIBITED
• The power cord included with this projector is exclusively for use with this projector. For safety, do not use it with other
devices.
HAZARDOUS
VOLTAGE
• Handle the power cord with care. Damaging the cord could lead to re or electric shock.
- Do not place heavy objects on the cord.
- Do not place the cord under the projector.
- Do not cover the cord with a rug, etc.
- Do not scratch or modify the cord.
- Do not bend, twist or pull the cord with excessive force.
- Do not apply heat to the cord.
Should the cord be damaged (exposed core wires, broken wires, etc.), ask your dealer to replace it.
• Do not touch the power plug should you hear thunder. Doing so could result in electric shock.
DO NOT TOUCH
WITH WET
HANDS
• Do not connect or disconnect the power cord with wet hands. Doing so could result in electric shock.
Installation
Do not use in places such as those described below.
PROHIBITED
• Do not use in places such as those described below. Doing so could lead to re or electric shock.
- Shaky tables, inclined surfaces or other unstable places.
- Poorly ventilated spaces.
- Near a radiator, other heat sources, or in direct sunshine.
- Continual vibration areas.
- Humid, dusty, steamy, or oily areas.
- An environment where there are corrosive gases (sulfur dioxide, hydrogen sulde, nitrogen dioxide, chlorine, ammonia,
ozone, etc.).
- Outdoors.
- High-temperature environment where humidity changes rapidly and condensation is likely to occur.
DO NOT WET
• Do not use in places such as those described below where the projector could get wet. Doing so could lead to re or electric
shock.
- Do not use in the rain or snow, on a seashore or waterfront, etc.
- Do not use in a bathroom or shower room.
- Do not install under equipment that discharges water, such as air conditioners.
- Do not place vases or potted plants on the projector.
- Do not place cups, cosmetics or medicines on the projector.
Should water, etc. get inside the projector, rst turn o the projector’s power, then unplug the power cord from the power
outlet and contact your dealer.
UNPLUG THE
POWER CORD