Sharp XP-A201U-B - Page 13

EN-7
CAUTION
Power cord
Handling the power cord
REQUIRED
• The projector should be installed close to an easily accessible power outlet.
• When connecting the power cord to the projector’s AC IN terminal, make sure the connector is fully and rmly inserted. Be
sure to x the power cord using the power cord stopper. Loose connection of the power cord could lead to re or electric
shock.
Handling the power cord by following below to avoid re or electric shock
REQUIRED
UNPLUG THE
POWER CORD
• When disconnecting the power cord, pull the power cord out by holding onto its plug.
• Unplug the power cord from the power outlet before cleaning the product or when not planning to use the product for an
extended time.
• When the power cord or plug is heat or damaged, unplug the power cord from the power outlet, and contact your dealer.
Periodically clean dust and other debris from the power plug
REQUIRED
• Failure to do so could result in re or electric shock.
Disconnect power cords and other cables before moving the projector
REQUIRED
• Before moving the product, make sure the product power is o, then unplug the power cord from the power outlet and
check that all cables connecting the product to other devices are disconnected.
Do not use the power cord with a power tap
PROHIBITED
• Adding an extension cord may lead to re as a result of overheating.
Installation
Securing the lens unit with the fall prevention wire
REQUIRED
• If the projector is going to be suspended from a ceiling or another high place, secure the lens unit using the fall prevention
wire (sold separately). If the lens unit is not secured, it may fall down if it comes lose.
On use
Do not use on networks subject to overvoltage.
PROHIBITED
• Connect the projector’s HDBaseT port and LAN port to a network for which there is no risk of overvoltage being applied.
Overvoltage applied to the HDBaseT or LAN port could result in electric shock.
Lens shift, focus and zoom operations
REQUIRED
• When shifting the lens or adjusting the focus or zoom, do so from either behind or the side of the projector. If adjustments
are performed from the front, your eyes could be exposed to strong light and get injured.
• Keep your hands away from the lens area when performing the lens shift operation. If not, your ngers could get caught in
the gap between the cabinet and the lens.