Sharp YO-290 - Entering Characters

5
Entering Characters
Moving the Cursor
Move the cursor by pressing j , l , k , or m .
Entering Characters
Entering letters and numbers
The initial setting for entering letters is small (lowercase) letters. To
enter capital (uppercase) letters, turn “CAPS” on by tapping
$ .
Other characters
Tap
s to display the symbol entry mode, allowing a total of 32
symbols and characters to be selected. To select the desired
symbol/special character, tap
s the appropriate number of
times at the position where you would like to insert it.
Characters assigned to
s :
Making Corrections
1. Inserting or Overwriting characters
Tap i , once or twice, to insert or overwrite characters.
2. Deleting characters
c can be used for deletion of data in Calculator mode and Rate
figure in Conversion mode.
d can be used for deletion of characters.
d can also be used to delete listings.
Touch Keyboard
Alphabet entry mode Number entry mode
• Each time f is tapped, the touch keyboard switches between the
Alphabet entry mode and the Number entry mode.
To tap the touch keys, use the stylus (included in the package).
• Tap towards the center of each key.
Loop Function
Right after the power is turned on, function modes can be browsed
through; every time
< key is pressed, the function modes will
sequentially be displayed as below:
Home Clock
➠ World Clock ➠ Personal ➠ Business ➠ Other ➠
Schedule ➠ Memo ➠ ...
Pressing the
> key will display the above menus in the reversed
order.
Press
x to select a desired mode; the Organizer will then escape
from the Loop function.
yo290e_u1u 02.5.22, 9:52 AM5