Sharp ZQ-4400

ZQ--4400
ZQ-4450
8. Select the data transfer function on the transmitter.
OPTION].
Note: To transfer an entry, display the entry to be transferred and
press OPTION}.
4. Perform data transfer.
1
© If the amount of memory available in the receiver at the time of
data transfer is insufficient, an error message appears. Delete any
unnecessary data, verify that there is sufficient memory available,
and repeat the procedure.
Transferring data from an EL series Organizer
1. Select the mode on the receiver.
2. Select the data transfer function on the receiver, and set it in the
receive mode.
3 Perform data transfer from the transmitter.
Exchanging data with a personal computer
With Sharp’s Organizer Link software and cable package, you can
exchange data with a personal computer. The link is made via the
4-pin computer-link port on the left side of the Organizer using an
interface cable to suit your computer. See the Organizer Link manual
for connection and software operating details.
Note: Sharp's Organizer Link software may not be available at the
time you purchase this Organizer. Check with your local
Sharp dealer concerning availability.
10. Reset procedure
When trouble occurs
An impact or a strong external electrical field may leave none of the
keys operational. Press the RESET switch on the back of the Or-
ganizer.
The impact or external electrical field may erasé sore or all of the
Organizer’s memory.
Press the RESET switch with the tip of a ball-point pen or similar
object, but rot anything breakable (like a pencil point or a needle).
All RESET operation
If a problem occurs after replacing the batteries, or if the Organizer
does. not function properly even after the above RESET operation,
perform the following:
1. While holding [ON], press the RESET switch on the back.
Release the RESET switch and then release [ON].
The following display will appear.
CLEAR ALL DATA
OK (Y/N) ?
2. Press [[N_].
Returns to the initial display.
Caution: Do not press [_Y_]in step 2. Pressing will
delete all data stored in the Organizer and reset
the built-in clock.
11. Contrast adjustment
Adjust the display contrast to make the display easier to read.
1. Press [2nd] [FUNCTION].
FUNCTION >
MEMORY CHK
LCD
DATA DEL
& S |]
} A
2. Select "2 LCD CONT".
2
LCD CONT
v - DARK
A — LIGHT
3. Press [a] or ['¥] to darken or lighten the display as required.
The amount of contrast will change continuously when either [A]
or [¥] is held.
4. After adjusting the contrast, press [C-CE].
12. Turning the "beep" on and off
While" J§ " is displayed, a "beep" will sound when a key is
pressed. To turn the "beep" on and off, press . The "beep"
will not sourid after" J “ goes off. To tum the "beep" back on,
repeat the process.