- 3 -
TIME SETTING MODE
ALARM SETTING MODE
ALARM AND SNOOZE
• In the time display mode, Press “MODE” for 2 seconds to enter time setting.
The value to be set will start flashing.
• Time zone setting: The default is EST. Press “UP” or “DOWN” to select
PST, MST, CST, EST, AST or NST.
• In standard mode, press “ALM” quickly to enter alarm mode.
• In alarm mode, press “ALM” to turn the alarm ON or OFF. The alarm icon will appear to disappear.
• In alarm mode, hold the “ALM” button to enter the alarm setting mode. The hour value will
begin to flash.
• The setting order is Hour >>> Minute >>> Exit.
• Press “UP/RCC, MEM” to advance one step at a time. Or, press and hold it to advance
8 steps per second.
• Press “DOWN/CH” to go back one step at a time. Or, press and hold it to go back
8 steps per second.
• Press “MODE” (or no key for 20 seconds) so exit and save the setting.
The alarm will sound in the following sequence:
• 1 Beep for 1-10 seconds.
• 2 Beeps for 11-20 seconds.
• Press “MODE” (or no key for 20 seconds) so exit and save the setting.
• Repeat this process to set the other values.
• Press “UP/RCC, MEM” to advance one step at a time. Or, press and hold it to advance
8 steps per second.
• Press “DOWN/CH” to go back one step at a time. Or, press and hold it to go back
8 steps per second.
• Press “MODE” (or no key for 20 seconds) so exit and save the setting.
If you would like the clock to set itself, simply leave it alone and it should sync overnight with the U.S.
Atomic Clock. Or, you may set it manually with the following steps:
• NST: Newfoundland Standard Time
• AST: Atlantic Standard Time
• EST: Eastern Standard Time
• CST: Central Standard Time
• MST: Mountain Standard Time
• PST: Pacific Standard Time
To Next Page
Loading...
