KEEP WARM
Bread can be automatically kept warm for 1 hour after baking. During keep warm, if you
would like to take the bread out, switch the program off by pressing the START/STOP
button.
MEMORY
If the power supply has been interrupted during operating, the process of making bread will
be continued automatically within 20 minutes, even without pressing “START/STOP” button.
If the interruption time is longer than 20 minutes and the display shows the initial default
setting, then you must discard the ingredients in the bread pan and add new ingredients into
the bread pan then the bread maker must be restarted. If the dough has not entered the
rising phase when the power supply is interrupted, you can press the “START/STOP” button
directly to continue the program from the beginning.
ENVIRONMENT
The machine may work well in a wide range of temperatures, but there may be some
difference in loaf size between a very warm room and a very cold room. We suggest that the
room temperature should be within the range of 15℃ to 34℃.
WARNING DISPLAY
1. If the display shows “HHH” after you have pressed START/STOP button, it means that the
temperature inside the bread pan is too high. You should stop the program and unplug from
the power outlet immediately. Then open the lid and let the machine cool down completely
before using again (except the program of BAKE and JAM). If the display shows “LLL” after the
program has been started, it means that the temperature inside of bread pan is too low. You
should place the bread maker into an environment of higher temperature for use (except the
program of BAKE and JAM).
FOR THE FIRST USE
The appliance may emit a little smoke and a characteristic smell when you turn it on for the
first time. This is normal and will soon stop. Make sure the appliance has sufficient ventilation.
1. Please check that all parts and accessories are complete and free of damage.
2. Clean all the parts according to the section“CLEANING AND MAINTENANCE”.
3. Set the bread maker on BAKE mode and bake empty for about 10 minutes. Then let it cool
down and clean all the detached parts again.
4. Dry all parts thoroughly and assemble them; the appliance is ready for using.
To Next Page
Loading...