Why can't my Sherwood NewCastle R-772 receive preset stations?
If your Sherwood Receiver cannot receive preset stations, it may be because an incorrect station frequency was memorized. Try memorizing the correct station frequency. Alternatively, the memorized stations may have been cleared, in which case you should memorize the stations again.
What causes hissing noise during AM reception on my Sherwood Receiver?
If you are experiencing continuous or intermittent hissing noise during AM reception, especially at night, on your Sherwood Receiver, this noise is likely caused by motors, fluorescent lamps, lightning, or other sources. Try to keep the receiver away from these noise sources.
General| Channels | 7.1 |
|---|---|
| Total Harmonic Distortion | 0.08% |
| Input Sensitivity | 200 mV (line) |
| Signal-to-Noise Ratio | 100 dB |
| HDMI Inputs | 4 |
| AM/FM Tuner | Yes |
| Power Output | 100 watts per channel (8 ohms) |
| Frequency Response | 10 Hz - 100 kHz |
| Video Connections | Composite, Component, HDMI |
| Tuning range | FM: 87.5-107.9 MHz, AM: 530-1710 kHz |
| Speaker load impedance | 4-16 ohms |
| Dimensions | 440 x 165 x 430mm |
Details on equipment testing and compliance with FCC regulations for digital devices.
Instructions for connecting FM and AM antennas for optimal signal reception.
Guide to connecting various video sources like DVD players, VCRs, and TVs.
Steps for connecting audio sources like tape decks and MD recorders.
Guidance on connecting optical and coaxial digital audio sources.
Detailed instructions for connecting various speaker configurations, including bi-amping.
Instructions for connecting RF remote antennas and multi-room system kits.
Identification and function of all buttons and jacks on the receiver's front panel.
Explanation of the various indicators and information shown on the receiver's display.
Steps to set up and operate other audio/video components using the universal remote.
Guide to entering setup codes, searching codes, and programming macro functions.
How to use the dedicated remote for ROOM 2 source playback.
Steps for powering on the receiver and selecting audio/video input sources.
Detailed description of all available DTS and Dolby Digital surround sound modes.
Instructions for tuning into AM/FM radio stations, including auto and manual tuning.
Guide to subscribing and listening to XM Satellite Radio.
Details on sleep timer, display brightness, and audio information display.
Procedures for recording analog and digital audio/video signals.
How to access and navigate through the receiver's on-screen display menus.
Configuration settings for amplifier assignment, subwoofer mode, and HDMI audio.
Guide to automatic and manual speaker setup, distance, crossover, and room equalization.
Adjusting individual channel levels, sound modes, and equalization parameters.
Setting up ROOM 2 playback and configuring input source assignments.
List of setup codes for programming the remote to control various TV, VCR, and DVD brands.
To Next Page