Shibaura SG280E - Grass Discharge and Mowing Performance

29
2929
29
DRIVING AND WORK
⑤
⑤⑤
⑤ Discharge of grass
● Grass clippings are forcefully discharged
.
For safety, keep the discharge
outlet cover
always in position.
● Do not direct the discharge
outlet to people
during operation.
● Before removing
grass from the mower, be
sure to stop the engine and wait for the
blades to stop rotating.
This mower is designed to discharge grass
after being cut evenly. When cutting tough,
thick or tall grass,
significant load is applied to
the mower. Decrease the forward
speed or
mowing width in such a case.
[Caution for Handling]
Keep the mower main body and inside of the
discharge
outlet cover clean for smooth
discharge.
⑥
⑥⑥
⑥ Points of issues and solution
● Uneven mowing
Uncut turf remains in rows because
of wear
or deformation of the blade or too low engine
s
peed. Check the blade for length, wear or
deformation, or engine speed and operation
speed.
● Separation of turf
Turf or ground is partially scraped off when
the blade is too low. Check the blade height,
for foreign substances entangled in the
blades, blade installing condition, tyre
pressures, etc. in such a case.
● Partial residue
If some grass remains uncut, check
for too
low engine speed, a build up of grass in the
mower deck,
too high running speed, and slip
of clutch belt or mower belt.
● Wavy cutting
Difference of turf density or grass
height,
unevenness of ground surface, or other
problems of the area to be cut
may be the
cause. Check that the mower gauge wheels
are in contact with the ground, build up of
grass in the cutter deck, wear or deformat
ion
of blade or traveling speed.
● Uneven mowing height
Cause is different mowing height between
right and left sides. Check the mower gauge
wheel for correct height of cut position,
deformation of blade and blade shaft, blade
installing direction, or even air pressure of
right and left tires of the vehicle, in such a
case.
Warning