INSPECTION AND MAINTENANCE
13. Inspecting and Adjusting the Fan Belt
tt
t
● Be sure to stop the engine.
●
Inspect and adjust the fan belt after the
engine has completely cooled down. If not,
you may get burnt.
Open the bonnet, push an intermediate point of
the fan belt by a force of about 100N (10kgf)
and check that the deflect
about 10 to 15mm and check for damage of the
belt.
If the deflection is not correct
alternator tightening bolt and adjust the tension
by moving the alternator. If the belt slips after
the alternator is moved, replace the belt
new one.
Caution
Front wheel pivot shaft
Power steering
cylinder (at 2 points), tie rod
end (2 points)
Rolling seat
PTO shaft (front end)
Fig. 8-17
Fig. 8-18
Fig. 8-19
To Next Page
Loading...
