Shibaura SG280E - Page 7

6
66
6
SAFETY RULES
5) Check the deflector and grass-catcher
frequently for wear and deterioration.
6) For reasons of safety, do not use the
equipment
with worn or damaged parts.
Parts are to be replaced and not repaired.
Use genuine spare parts. Parts which are not
of
an equivalent quality can damage the
equipment and could
be dangerous for your
safety.
7) If the fuel tank has to be drained, this should
be
done outdoors and when the engine is cool.
8) Wear strong work gloves when removing and
reassembling the blades.
9) Check the blades’ balance after sharpening.
10) Take care as the rotation of one blade can
cause the other blade to turn.
11) When the machine is to be parked, stored
or left
unattended, lower the mower deck.
12) The ignition key must never be left inserted
in
the machine, or where children or
persons not
familiar to the machine may reach them.
Before any maintenance or repair, remove
the
ignition key.
13) Conduct operation and inspec
tion during
daytime or under bright lighting.
14) Stop engine before servicing ,adjusting ,
repairing this machine.
15) Do not work under a raised attachment unle
ss it
is securely supported by a suitable hoist or floor
jack and multiple jack stands.
16)
When you work under the machine, support it
firmly with such a crane, hoist or rigid racks on a
level place. If not It may cause severe
accidents.
17)
Never perform service underneath the
machine if it is not completely stable.
18) Be careful of Hot Oil Under High pressure.
The
hydraulic system for the implement
operates under high pressure. When
replenishing or draining hydraulic oil, be sure
to first relieve the high pressure.
19) Be sure to disconnect the (-)
terminal of
battery before servicing. If not short circuit
may cause a fire.
20) HANDLING BATTERY ELECTROLYTE
-
The battery electrolyte is diluted sulfuric acid
and poisonous. Top up battery electrolyte in
well ventilated area and wear eye protection
and rubber gloves. Splashed solution can
cause burning skin, clot
hes and blindness if it
get into eyes.
21)
Do not modify or alter or permit anyone else
to modify or alter this machine or any of its
components and functions without first
consulting SHIBAURA’s Dealer.
E) TRANSPORTING
The method of loading & un-
loading on the
truck Please do the loading and unloading work
on the flat & safety place.
1) Loading on the truck
-
Stop the truck engine and set the parking
brake.
-
Put the hook of the ramps on the truck floor
firmly so that the ramps will not come off.
-
Load the tractor vehicle into truck slowly by
moving the vehicle forward. (* in case that the
implement of installation is mower deck)
-
Load the tractor vehicle into truck by moving
the vehicle forward on the ramps.