SECTION 4 – SXM54, SXM60 MOWER DECK
4-12
9. Connect the rear linkage ③ to the deck
using the spring-loaded handle ④.
10. Repeat for the opposite side.
11. Connect the front linkage ① to the mower
deck using the spring-loaded handle ② .
Connect the opposite end of the front linkage
to the tractor using the spring loaded handle
③.
12. Repeat for the opposite side.
13. Remove the PTO cap from the PTO shaft.
14. Pull the driveshaft locking collar ① towards
the front of the tractor and slide the
driveshaft ② onto the PTO shaft ③.
To Next Page
Loading...
