-76-
Menu Map item [44] (on positive load and on zero)
Load the sample when the value displayed is within the Zero Range. When the
stability symbol has illuminated and the positive displayed value is more than
5 times the Zero Range, data is automatically output.
Unload the sample or press the
key. When the displayed value is
within the Zero Range and the stability symbol has illuminated, data is output
again.
Menu Map item [45]
(on positive or negative load and on zero)
Load the sample when the value displayed is within the Zero Range. When the
stability symbol has illuminated and the displayed positive or negative value is
more than 5 times the Zero Range, data is automatically output.
Unload the sample or press the
key. When the displayed value is
within the Zero Range and the stability symbol ha illuminated, data is output
again.
Menu Map item [46]
(on /continue)
By pressing the
key while the and symbols are lit, the
symbol goes out, the symbol lights and the displayed data is
continuously output.
Continuous output stops temporarily when the
key is pressed.
Note: During continuous output, the
symbol may appear to remain lit. If the transfer
speed of the data output is slow, the display may flash. Increase the transfer speed as
much as possible and set the handshake to
.
Menu Map item [47] (on / go)
When the graphic display is in Comparator mode (Group mode or Level
mode) and the stability symbol lights in the GO range, the data is output once.
The next data output is executed after the displayed value is within the Zero
Range.
2.9.5 Peak Hold
Menu Map item [49] measures the displayed peak value. The
symbol is illuminated when
the Peak Hold function is activated.
"Peak value" is the highest or lowest stable value displayed after the display has changed
beyond five times the Zero Range.
To Next Page
