Shimadzu ECD-2010 Exceed - Emergency Procedures

n In an Emergency
If you find that the GC-2010 Plus has malfunctioned, immediately perform an emergency
stop.
Also, prior to starting the system again, inspect the instrument thoroughly and, if
required, contact your Shimadzu representative.
Emergency Shutdown Procedure
1
Turn OFF power to the GC-2010 Plus.
2 Turn OFF power on all the peripheral units.
3 Close the main valves for carrier gas and makeup gas.
4
Unplug the power supply cable from the socket to shut the power off.
If the GC-2010 Plus unit’s power cable is connected to a power distribution board,
turn OFF the board’s switch.
n During a Power Outage
Take the following measures in the event of a power outage.
1
Immediately turn OFF the supply of gas.
2
Switch OFF power to the GC.
3
Open all windows and doors of the room to thoroughly ventilate it.
4
After the power is reinstated, use the standard procedure to start the GC.
vi
ECD-2010 Exceed
Introduction