MOC63
UniBloc Moisture Analyzer
.
Automatic ending mode
Automatically ends measurement when
moisture loss over the previous 30 seconds
becomes smaller than specified percentage.
.
Timed ending mode
Automatically ends measurement when the
specified amount of time has elapsed.
.
Rapid drying mode
First dries with the highest temperature for
the specified period, then shifts to the
specified temperature shortening
measurement time.
.
Slow drying mode
Gently heats samples that might solidify at
the surface or samples that reduce under
high temperature.
.
Step drying mode
Allows step by step change of drying
conditions . This feature is useful when
measuring samples that contain a large
amount of water.
Ending modes
Temperature
Moisture
vaporization
Set ending time
Temperature
Moisture
vaporization
Ending drying
Temperature
Moisture
vaporization
Temperature
Temperature
Moisture
vaporization
Temperature
Moisture
vaporization
Automatic ending
Moisture vaporization
over 30 seconds
Temperature
Predicted moisture
vaporization
Predicted
measurement time
Alternate Drying modes
.
Automatic starting mode
This mode allows to start measurement only
closing lid.
It will save time in repeated measurement.
Starting mode
Measurement mode of MOC63
Floor
Floor
Floor
Floor
Floor
Floor
Floor
Floor
Floor
Floor
Floor
Orange juice
Paint
Automatic ending mode and timed ending mode is applicable for almost many sample. However, it takes time to
measurement or has a problem that the sample is burned or dissolved sometimes. You can select as above mode for
more reliable and rapid measurement.
○
○
○
○
○
○
○
○
○
○
○
○
○
Choice of measuring modes your application. Recommended measurement mode for each samples
Rapid drying
mode
Timed ending
mode
Slow drying
mode
Step drying
mode
Automatic
ending mode
54
ダミー
To Next Page
Loading...
