To Next PageTo Next Page
Need help?Do you have a question about the Shimadzu TXB622L and is the answer not in the manual?
General| Maximum Capacity | 620 g |
|---|---|
| Readability | 0.01 g |
| Calibration | External |
| Display | LCD |
| Repeatability (σ) | 0.01 g |
| Linearity | ±0.02 g |
| Operating Temperature | 5°C to 40°C |
| Power Requirements | AC adapter |
| Interface | RS-232C |
| Stabilization Time | 1.5 seconds |
| Units of Measurement | g, ct, oz |
| Power Supply | AC 100V to 240V, 50/60Hz |
Details the main body and back of the unit components for TW/TX and TXB series balances.
Covers site selection, unpacking, component fitting, and leveling procedures for balance setup.
Explains how to enter weighing mode, place containers, and measure samples.
Outlines types of calibration and setting the preferred operation.
Details the procedure for adjusting balance sensitivity using internal or external weights.
Explains how to check for sensitivity drift using internal or external weights.
Describes recalibrating the built-in internal weight.
Introduces Piece Counting, Percentage Weighing, and Formulation modes.
Explains setting unit weight and counting items.
Covers weighing samples as a percentage of a reference weight.
Details mixing multiple components by weight according to a formula.
Explains comparing weight to target values and displaying status.
Covers setting target values and tolerance ranges for comparison.
Explains transferring data to PC without software.
Provides a symptom-based guide for common display and operational issues.
Explains error messages and their probable causes and countermeasures.
