Shimano Steps BT-E8036 - Satellite System ON;OFF Switch Installation

49
Installation/removal
Installing the satellite system ON/OFF switch
(2) Close the charging port cap, and secure the satellite charging port.
Mounting screw
Section A
Charging port cap
(1) (2)
0.6 N·m
NOTICE
• Section A in the figure is part of the charging port cap. When installing the
satellite charging port, be careful that section A is not pinched by the frame.
Installing the satellite system ON/OFF switch
EW-SW100 / EW-SW300
NOTICE
• The work procedure and tightening torque may vary depending on the design of the
frame. Contact a distributor for details.
1. Connect the electric wire of the satellite system ON/OFF switch.
• The electric wire may need to be connected after installing the satellite system ON/OFF
switch, depending on the design of the frame.