Shimano Steps EC-E6000

Other manuals for Shimano Steps EC-E6000

Dealer's Manual57 pages

User Manual36 pages

Questions and Answers

R
Rebecca HowardSep 3, 2025
What to do if the key does not turn on my Shimano Steps Camera Accessories?
- P
  plewisSep 4, 2025
  If the key does not turn on your Shimano Steps Camera Accessories, foreign material such as dirt or dust may be stuck in the battery or battery mount. Turn the key while pushing the battery in the installation direction. If the battery is removed, follow the cleaning procedure to clean it.
C
Cheryl WelchSep 18, 2025
What to do if the key does not turn on my Shimano Steps?
- D
  derekolsenSep 18, 2025
  If the key on your Shimano Steps does not turn, it could be due to foreign material, such as dirt or dust, stuck in the battery or battery mount. Turn the key while pushing the battery in the installation direction. If the battery is removed, follow the cleaning procedure to clean it.
J
Jason BurgessSep 16, 2025
Why does my Shimano Steps cycle computer not start?
- K
  Kimberly TranSep 16, 2025
  The cycle computer may not start for the following reasons: * If the battery is charging while installed on a bicycle, you cannot turn the cycle computer on. Stop charging. * If the cycle computer doesn't start when the power button is pressed, the built-in battery of the cycle computer may be low and needs to be charged.
A
Anthony TrujilloSep 14, 2025
Why does the LED light not turn on when I press the satellite system on/off switch on my Shimano Steps?
- C
  Clayton BrooksSep 14, 2025
  If the LED light doesn't light up at all after pressing the satellite system on/off switch on your Shimano Steps, it could be due to a couple of reasons: * If it has been left unused for a long time, the built-in battery of the satellite system on/off switch may need to be charged. * The battery's temperature might be outside its operating range. Try turning the power on after leaving the battery for a short while in a temperature range where discharge is possible.
M
meyersteveSep 12, 2025
Why is my Shimano Steps Battery Charger so hot?
- K
  kevinsalazarSep 12, 2025
  If the Shimano Steps Battery Charger is hot, it may be hotter than normal because you are charging multiple batteries in succession. Wait a while between charges.
A
Amanda HoltSep 12, 2025
What to do if the Shimano Steps cycle computer screen turns on briefly but the power won't stay on?
- D
  Daniel HarmonSep 12, 2025
  If the screen of the cycle computer or the LED of the satellite system turns on briefly when the satellite system on/off switch is pressed, but the power won't turn on, it could be due to a few reasons: * The main battery level might be too low. Charge the main battery. * The main battery might not be properly connected. Check that it is securely connected. * The built-in battery of the satellite system on/off switch might be too low. The built-in battery needs to be charged.
G
Gary GreenSep 9, 2025
Why do my Shimano Steps Battery and Battery Charger become hot?
- M
  Mary MonroeSep 9, 2025
  If your Shimano Steps Battery and Battery Charger become hot, it might be because their temperature exceeds the operating temperature. Stop charging and wait before starting again. The surface temperature may exceed 60°C due to the environment, depending on the model.
G
Gina RichmondSep 7, 2025
Why is the LED light off on my Shimano Steps Battery Charger?
- J
  joshua69Sep 7, 2025
  If the LED on your Shimano Steps Battery Charger doesn't light up, check the following: * Ensure the charging plug is securely inserted into the battery. Check for any foreign material in the connection area, and remove and reconnect the charging plug. * If the battery is fully charged, the LED turns off, which is normal. Try removing and reconnecting the power plug of the battery charger, and then charge again.
R
Rachel TorresSep 5, 2025
Why won't my Shimano Steps Camera Accessories cycle computer start?
- R
  ramoslouisSep 5, 2025
  When charging with the battery installed to a bicycle, you cannot turn the cycle computer ON. Stop charging. The power automatically turns OFF if charging is started while the cycle computer is running.
J
Jennifer BowersAug 20, 2025
What to do if my Shimano Steps Battery Charger cannot charge?
- N
  Nicholas CamachoAug 20, 2025
  If your Shimano Steps Battery Charger is not charging, here are a few things to check: * Make sure the power plug of the battery charger is securely connected. Remove and reconnect it, and then try charging again. * Ensure the charging plug of the battery charger is securely inserted into the battery. Remove and reconnect it, and then try charging again. * Verify that the charging adapter and charging plug, or the charging adapter and battery charging port, are securely connected. * Check the connection terminals of the battery charger, charging adapter, or battery for dirt. If they are dirty, clean them with a clean rag or cotton bud dampened with ethanol, and then try charging again.