35
Clearing the traveling distance
You can clear the traveling distance in the main screen. If the battery-powered light is connected and configured, clear
the traveling distance (DST) according to "Clear" in "About the settings menu".
*
When using the SC-E6000 this function can only be used when the light is not connected.
1.
Change the traveling data display to DST and press
the Assist-A for 2 seconds.
< SW-E6000 >
Assist Shift
2 Sec.
< SW-E6010 >
< SC-E6010 >< SC-E6000 >
Assist Shift
2 Sec.
2.
Release the finger when the DST indication starts
blinking.
In this state, pressing the Assist-A again clears the
traveling distance.
• The DST indicator light stops blinking and the screen
takes you back to the basic screen after leaving it alone
for 5 seconds.
• When the traveling distance is cleared, TIME, AVG, and
MAX are also cleared.
< SC-E6010 >< SC-E6000 >
To Next Page
Loading...
Need help?
General
