52
Error messages on the cycle computer
Warnings
This disappears if the error is fixed.
< SC-E6000 > < SC-E6010 >
Code
Display
preconditions
Operational restrictions
while warning is
displayed
Remedy
W031
The chain tension may
not have been adjusted
or the crank may have
been installed in the
wrong position.
The assist function is
not available. (However,
electronic gear shifting
will still function.)
Contact the place of purchase or bicycle dealer.
< SC-E6010 >
List of warnings
Code
Display
preconditions
Operational restrictions
while warning is
displayed
Remedy
W010
The temperature of
the drive unit is high.
The level of assistance
may decrease.
Stop using the assist function until the temperature of
the drive unit drops.
If the situation does not improve, contact the place of
purchase.
W011
The traveling speed
cannot be detected.
The maximum speed up to
which power assistance is
provided may decrease.
(Power assistance is provided
up to 25 km/h in top gear.)
Contact your place of purchase or a local bicycle dealer
for assistance, since there is a chance of the following:
• The speed sensor is installed in the wrong position.
• The magnet included with the disc brake rotor has
come off.
W012
The crank may be
installed in the
wrong direction.
-
Install the crank in the correct direction, then turn on
the power again.
To Next Page
Loading...
Need help?
General
