Need help?Do you have a question about the SHIMGE SGJW Series and is the answer not in the manual?
Motor fails to rotate due to cable issues, blocked impeller, burnt winding, low voltage, or capacitor damage.
No water flow despite motor running, caused by air leaks, blocked valves, seal issues, low water level, or impeller damage.
Low flow rate due to pipeline issues, blocked valves, impeller damage, blockages, reverse motor rotation, or low water level.
Sudden shutdown from tripped switch/fuse, blocked impeller, burnt winding, or motor overload.
Stator winding failure caused by low supply voltage, water ingress, blocked impeller, frequent starts, or overload.
Excessive noise due to impeller/body rubbing, damaged bearing, or cavitation.
General| Model | SGJW Series |
|---|---|
| Category | Water Pump |
| Liquid Temperature | 0 - 40 °C |
| Protection Class | IP68 |
| Maximum Immersion Depth | 5 m |
| Voltage | 220-240 V |
| Frequency | 50 Hz |
| Outlet | 1 inch |
| Material | Stainless Steel |
| Inlet/Outlet Size | 1 inch |
To Next Page
