- - 7 - -
Control panel
Control Panel Instructions (Right to Left)
POWER: Press this button to turn on or off the air conditioner. The indicator
light will show if the unit is on.
MODE：When unit is turned on or set with TIMER on, pressing this button can
cycle between COOL/DRY/ FAN modes. The corresponding indicator lamp to
the selected mode shows what MODE is currently running.
UP/DOWN：If the TIMER is set to on, pressing UP or DOWN will adjust the
timer setting. While running on COOL mode, pressing UP or DOWN will adjust
the temperature. Pressing UP and DOWN simultaneously can cycle
between ℃ and ℉. (℃ is displayed as default)
TEMP GAUGE：The display will show the current set temperature in COOL
and HEAT modes; while in FAN and DRY modes, the display will show current
room temperature. If light indicator is lit for ℃, it will display this information in
Degrees Centigrade; if light indicator is lit for ℉ it will display this information in
Degrees Fahrenheit.
WATER FULL: The indicator light will show when the internal bucket is full.
SLEEP: The indicator light will show when the unit is in SLEEP mode.
SPEED：Pressing this button can select different fan speeds between
HIGH/MID/LOW. While in FAN mode, press this button for 5s to run the
internal DRY function, and press this button for another 5s to cancel. The
indicator light will show the currently selected speed.
TIMER：Press this button to enter TIMER setting state. The indicator light will
show if the TIMER setting is on.
ATTN: if the air conditioner is restarted immediately after shutdown in COOL
mode, there will be a 3-minute protection time before compressor kicks on. This
is to prevent overheating of the compressor.
To Next Page
Loading...
Need help?
General
