Need help?Do you have a question about the Shindaiwa 300 and is the answer not in the manual?
Explains the operating theory of a two-stroke engine.
Provides a checklist for common engine starting and running issues.
Covers the causes and diagnosis of engine seizure.
General procedures for carburetor adjustment on all saw models.
Procedure for adjusting the high-speed fuel mixture.
General steps for diagnosing ignition system problems.
How to inspect and troubleshoot the spark plug.
Procedures for testing various ignition system components.
Step-by-step instructions for removing the clutch assembly.
Instructions on how to remove the piston from the cylinder.
Methods for separating the crankcase halves.
How to inspect the crankshaft for damage and runout.
Procedures for correctly installing crankcase seals.
How to adjust the chain brake for proper operation.
How to test the chain brake for proper function.
Diagnosing and solving common oil pump issues.
How to inspect A-V cushions and rear handle for wear.
Procedures for reassembling the rear handle and A-V cushions.
Steps for removing the powerhead assembly.
Procedures for initial startup and carburetor adjustments.
Explains the operating theory of a two-stroke engine.
Provides a checklist for common engine starting and running issues.
Covers the causes and diagnosis of engine seizure.
General procedures for carburetor adjustment on all saw models.
Procedure for adjusting the high-speed fuel mixture.
General steps for diagnosing ignition system problems.
How to inspect and troubleshoot the spark plug.
Procedures for testing various ignition system components.
Step-by-step instructions for removing the clutch assembly.
Instructions on how to remove the piston from the cylinder.
Methods for separating the crankcase halves.
How to inspect the crankshaft for damage and runout.
Procedures for correctly installing crankcase seals.
How to adjust the chain brake for proper operation.
How to test the chain brake for proper function.
Diagnosing and solving common oil pump issues.
How to inspect A-V cushions and rear handle for wear.
Procedures for reassembling the rear handle and A-V cushions.
Steps for removing the powerhead assembly.
Procedures for initial startup and carburetor adjustments.
General| Engine Type | 2-stroke |
|---|---|
| Chain Pitch | 3/8 in |
| Chain Gauge | 0.050 in |
| Oil Tank Capacity | 0.20 liters |
| Bar Length | 35 cm (14 in) |
To Next Page
